Week 9 : Mono Print

---

---

The Process :

---

Method (1)

Step 1: Use a roller to fill the rubber plate with ink on the plastic board.

---

Step 2: Put the paper onto a board and used the pencil to draw the desired pattern on the paper, such as a butterfly.

---

Step 3: After finishing the drawing, take the paper off carefully, and then finished! You could see the figure that you draw will appear a dark colour.

---

Method 2 :

Step 1: Use a roller to fill the rubber plate with ink on the plastic board.

---

Step 2: Draw the design directly on the ink-filled plastic plate with a pencil.

---

Step 3: After finishing the drawing, put the paper on the plastic board and used a clean roller to roll harder on the paper. Then, take it off carefully, and finished! You could see the figure that you draw will appear a light colour.

---

Remember to put them on the table and wait for dry

---

My Reflection :

After finishing these printing, I noticed that we couldn't press the paper too hard, and we need to draw the figure carefully and focus. Also, we should pay attention to the ink on the plastic plate can not be too much and too dark.

---